{% set devicename = "esphome_plug08"  %}

{% include "/includes/ansible.inc.yaml" %}
{% include "/includes/board.esp01_1m.inc.yaml" %}

  comment: WLED Vorhang
{% include "/includes/common.inc.yaml" %}

  on_message:
    - topic: ESPHome/{{ devicename }}/state/command
      payload: "ON"
      then:
        - switch.turn_on: relay
    - topic: ESPHome/{{ devicename }}/state/command
      payload: "OFF"
      then:
        - switch.turn_off: relay
    - topic: warpzone/door/status_once
      payload: "OPEN"
      then:
        - switch.turn_on: relay
        
substitutions:
  plug_name: {{ devicename }}
  # Higher value gives lower watt readout
  current_res: "0.00221"
  # Lower value gives lower voltage readout
  voltage_div: "920"

binary_sensor:
  # Binary sensor for the button press
  - platform: gpio
    name: "${plug_name}_button"
    pin:
      number: GPIO3
      inverted: true
    on_press:
      - switch.toggle: relay
      

   
switch:
  - platform: gpio
    id: relay
    name: "${plug_name}_Relay"
    restore_mode: ALWAYS_OFF
    pin: GPIO14
    on_turn_on:
      - light.turn_on: led
    on_turn_off:
      - light.turn_off: led
sensor:
  - platform: hlw8012
    sel_pin:
      number: GPIO12
      inverted: True
    cf_pin: GPIO04
    cf1_pin: GPIO05
    current_resistor: ${current_res}
    voltage_divider: ${voltage_div}
    current:
      name: "${plug_name}_Amperage"
      unit_of_measurement: A
    voltage:
      name: "${plug_name}_Voltage"
      unit_of_measurement: V
    power:
      name: "${plug_name}_Wattage"
      unit_of_measurement: W
      id: "${plug_name}_Wattage"
    change_mode_every: 8
    update_interval: 10s
  - platform: total_daily_energy
    name: ${plug_name}_Energy
    power_id: "${plug_name}_Wattage"

# Enable time for energy monitoring
time:
  - platform: sntp
    
output:
  # Relay state led
  - platform: esp8266_pwm
    id: state_led
    pin:
      number: GPIO1
      inverted: true

light:
  # Relay state light
  - platform: monochromatic
    output: state_led
    id: led

# Uses the red LED as a status indicator
status_led:
  pin:
    number: GPIO13
    inverted: true